Automotive transients can be wild. I did a bringup with a board that had specified 100+v range specified for transients and finicky quality requirements on the output. The power supplies took up most of the (very large) board.

▲

mixdup 10 hours ago | parent | next [-]

14v is not a transient, if your voltage was 12v with the car running, there's something wrong with the charging system (DC-to-DC in an EV, alternator/generator in an ICE)

13-14v is normal in all 12v automotive systems as the charging voltage

▲

nandomrumber 10 hours ago | parent [-]

If I recall correctly, a fully charged lead acid battery has an open circuit voltage of 13.6V.

So the alternator has to put out at least something higher than if it’s planning on recharging the battery after 500 to 700 amps have been pulled from it for a few seconds to start the engine.

▲

numpad0 8 hours ago | parent [-]

Yeah, max CV charging voltage is ~14V, max charging C rate is ~0.2C, open circuit voltage at 100% is that 13.x range. And lead acids like to stay at 100% unlike Li-ion which likes 50% +/-30%, so "12V" ICE cars just use a bus voltage of 13-14V and wire the battery there. At any given moment, the car's "12V" bus voltage MUST be above 13.x and below 14.4(absolute max).

It's a bit perplexing that those lead acid systems are referred to as "12V" systems when that figure is effectively the 0% voltage, whereas 3.7V for single Li-ion cell is the 50% voltage.

e: also, ICE transients can be in kV range, coming from ignition mechanisms. I've heard that you can literally measure engine RPM by selecting 1/dt on an oscilloscope and dividing that by cylinder count.

▲

K0balt 8 hours ago | parent [-]

The nominal range for automotive systems is 10-16v. If you are designing anything for automotive use that doesn’t work reliably in that range, you are manufacturing problems for people.

	▲	imp0cat 3 hours ago \| parent [-]
		This. Most cars nowadays come with the so-called "smart" alternators that vary voltage wildly depending on the current driving conditions. One minute you might be accelerating and the onboard voltage drops as the battery supplies most of electricity. Then, as you reach the crest of a hill and start engine-braking, the car frantically tries to convert all the available kinetic energy to electricity, raising the onboard voltage to quickly charge the battery.

▲

jeffreygoesto 3 hours ago | parent | prev [-]

Saw up to 800A on units like the FSD for the short time until the caps were full. Slow starting a SoC is a software problem, slow starting the Cs and keeping the impedance low at the same time a non-trivial hardware problem.