> Whenever I see another supposedly menial device including enough general purpose hardware

The PineBuds are designed and sold as an open firmware platform to allow software experimentation, so there’s nothing bad nor any economic failures going on here. Having a powerful general purpose microcontroller to experiment with is a design goal of the product.

That said, ANC Bluetooth earbuds are not menial products. Doing ANC properly is very complicated. It’s much harder than taking the input from a microphone, inverting the signal, and feeding it into the output. There’s a lot of computation that needs to be done continuously.

Using a powerful microcontroller isn’t a failure, it’s a benefit of having advanced semiconductor processes. Basically anything small and power efficient on a modern process will have no problem running at tens of MHz speeds. You want modern processes for the battery efficiency and you get speed as a bonus.

The speed isn’t wasted, either. Higher clock speeds means lower latency. In a battery powered device having an MCU running at 48MHz may seem excessive until you realize that the faster it finishes every unit of work the sooner it can go to sleep. It’s not always about raw power.

Modern earbuds are complicated. Having a general purpose MCU to allow software updates is much better than trying to get the entire wireless stack, noise cancellation, and everything else completely perfect before spinning out a custom ASIC.

We’re very fortunate to have all of this at our disposal. The groveling about putting powerful microcontrollers into small things ignores the reality of how hard it is to make a bug-free custom ASIC and break even on it relative to spending $0.10 per unit on a proven microcontroller manufacturer at scale.