From the install guide [1] under "Installation Instructions, General", step 5 is:

> Cut the positive wire to the third brake light and strip the insulation from both ends of the cut.

That's altering the factory wiring harness. That's an extra junction the factory didn't authorize and when it fails, the factory warranty won't cover it, because the wiring harness modification lead to the failure. All so the dealer can make about $250 extra on a sale.

If these were built as a module you plugged in between the wiring harness plug and the light module socket, I'd have a smidge less hate for them; but there's too many plug types for that, and there might not be enough room anyway, so the dealer has to cut into the wiring harness for this ... if there's a real benefit to flashing brake lights, it should be standardized and done by the manufacturers.

[1] https://pulseprotects.com/wp-content/uploads/2023/09/Sales-R...

▲

potato3732842 3 hours ago | parent [-]

They literally make drop in bulbs

https://www.ebay.com/itm/184234748289

	▲	toast0 2 hours ago \| parent [-]
		That'd be fine, I guess. But these guys [1] have more dealer sales outreach and they sell a module which you hack up the wiring to add. [1] https://pulseprotects.com/