Memory mapping happened automatically. Each card was mapped based on the slot it was in. $C000 - $C700 I believe with each slot assigned 256 bytes.

▲

kot_manul 19 hours ago | parent [-]

You're correct; slot 6 for instance is $C600. If you crashed to the system monitor you could boot a disk by entering C600G (with the 'G' standing for 'go to').

IIRC the disk controller had firmware that loaded the first 256 byte sector from disk into memory.

▲

Dwedit 18 hours ago | parent [-]

If you crashed to the monitor, you could hit Ctrl+B and get back to BASIC, then type IN#6 to boot the disk.

▲

Joe_Cool 17 hours ago | parent [-]

Yeah. It was neat. But it rebooted in under a second so a complete crash was no biggie.

RAM wasn't even cleared so usually no (or limited) data loss.

I thought it was PR#6 (redirect output) to boot from the disk controller in slot 6. I wonder what redirecting input would do.

▲

raw_anon_1111 17 hours ago | parent | next [-]

That was it at the AppleSoft BASIC prompt (or IN#6). But the parent poster commented on how to do it from assembly.

	▲	Joe_Cool 17 hours ago \| parent [-]
		There is an even quicker way from the monitor: 6 CTRL+P Will instantly divert output to slot 6. (and boot the disk if there is hardware there)

▲

Polizeiposaune 17 hours ago | parent | prev [-]

Both worked to start a boot from the disk controller in that slot.