I believe you're referring to 464XLAT (RFC6877 [0]) and yeah, you wouldn't -need- to have any ipv4 stack at all internally (except at the very edge of the network to number the PLAT devices [1]), but I believe it would cause a higher support burden for the nascent ISP than it would relieve by not having to run v4 and v6 together. There may be devices a customer owns that just doesn't support v6, or has weird bugs that would be a show-stopper for them. Should everything, ideally, be supporting IPv6? Yes, of course. Does v6 work seamlessly in all situations? Absolutely not.

I think the need to run a dual-stacked network, especially one that serves a wider customer base will be required for years, perhaps a decade or more, to come. If we were able to control every device and know it has a well-behaved v6 stack, then it might be a different story (which might be the case of T-Mo, as handset variations are limited in scope and well-defined in that scope, and behavior, mostly). But we still need v4 somewhere, and will continue to need it until the bulk of the internet is migrated.

I've had the luxury in the past of having complete control over the devices running in a v6-only network and even then it was a struggle to confidently say that everything had perfect connectivity at all times, even with tricks like 464XLAT or SIIT [2] at the edge. I can't imagine the pain of a network with heterogeneous customer devices running v6 stacks of varying quality.

Anyway, lots of words to say that it theoretically could be done, I just don't see it successfully being done with all of the variations in a consumer-facing network. The gulf between theoretical and the practical implementation is vast. Personally, the going rate for a block of /24 or /23 or whatever size is a small price to pay for compatibility.

[0] https://datatracker.ietf.org/doc/html/rfc6877

[1] https://datatracker.ietf.org/doc/html/rfc6877#section-2

[2] Stateless IP/ICMP Translation

You'll need at least one ipv4 address to hide your customers behind when they access an ipv4 network.

An ipv4 address costs $30 to purchase at a /24 level, less in larger amounts.

If you are providing service to a customer that's $2.50 a month for a year.

You don't. You can get some IP addresses from your upstream, use private IPs inside your network, and do CG-NAT on the border router.

Using IPv6 internally and using CGNAT or whatever translation layer you'd prefer for external IPv4 access would be the cheapest solution, but I think many of us would like to run dual stack. I can understand why someone would like their own larger IPv4 range when starting a new ISP.

> I've only seen that Cogent has a presence here, but the internet doesn't have good things to say about them

They’re good enough and they’re dirt cheap. Pricing really matters since you pass savings on to your customers. Vermont Telecom, as an example of a reasonably sized regional ISP with thousands of customers, uses Cogent as their primary upstream.

I wouldn’t fall into the trap of trying to build something out using hardware or upstream providers that people on Internet forums that don’t have a financial stake in making an ISP work financially and operationally approve of.

I think Cogent has earned their vibes, but if they're all you can get near you, they're ok enough to get started with.

As you get bigger, you can put a router somewhere (or two somewheres) with cogent and more options and transport through cogent to get back to your service area. Looking at your profile, I think if you can get traffic to Denver, you should have more options there.

Cogent can sell you transport to an IX where you'll get lots of traffic for free.

You don't have to buy IP transit from who sells you physical connectivity.

I've heard they have good connectivity with Comcast.

Consider one of their customers, FDC.

Cogent is fine for most purposes. They have some odd choices upstream at times but for a smaller project, it shouldn’t be a problem. Later on you could look at a dedicated wave or ring (or tunnel, lots of options!) to another facility that has more diversity and peer through that, but make it work first!